******************************************************************************
*File: 001 High powered gas canister bomb.txt             www.swateam.org.uk *
*SWAT c00kb00k version v1.2			   Last b00k Update 13/03/06 *
******************************************************************************

Here's a simple to construct device that will ensure the total destruction
of any confined space! If unleased in the open air (i.e outdoors) just be sure
of huge fireballs going skyward!


Materials Needed:
3 Cans of lighter gas (Highly recommended)
  or 6 Cans of lighter fluid (If you intend to flood the area with a river of fire)
   (non-recommended substitute(s) - hair spray/any butane/propane powered aerosol)

1 Copper pipe 25cm long - 1.5-2cm wide
3 Cotton wool balls
1 LONG Fuse
A box or two of shotgun shells

Knife
Saw
Hammer
Pair of pliers

String.

Device construction:


1: Pound one end of the pipe flat and fold it over at least twice.



2: Use the saw to cut a small hole in the center of the pipe.


3: Now open up the shotgun shells and tip the powder (Nitrocellulose)
   into the pipe. You may want to put some tape around the base of the
   fuse to hold it in place. Make sure that there is about 5cm of pipe
   with no powder in it.



4: Place the cotton wool balls in the open section of pipe and carefully
   close the end and fold it over.


5: Now tie the cans around the pipe bomb very tightly, you might have to
   tape the fuse to the edge of the pipe so that it runs up it. try not
   to use so much tape as to put the fuse out when it burns past it.



Deploying the device:

The usual, light the fuse, throw the bomb and run tactic works well, esp
if its left in places like cars of sheds! phoneboxes don't usually withstand the
blast too well either.

Its easy to rig up with an electrical timer so it can also be left places for 
long periods of time (a loft perhaps?).

Enjoy!